Going too deep and causing loss of traction and ground speed. It should be possible for the blade to do this automatically using DRAFT mode. Point where the implement is at the desired depth. Control tire slip by raising the blade slightly. To limit the degree, the implement can be lowered, set the position control lever at the lowest working depth desired for the implement. This is the lightest, or shallowest, draft setting you can acheive.
8N DRAFT CONTROL FULL
If you carefully move the control lever, from full up, down very slowly, you will reach a point where the implement will slowly drop. However, the implement sometimes lowers too much. In the down postion, the touch control lever sets the 'draft' you want for the implement you are using. Mixed control: In draft control, when draft decreases, the implement automatically lowers to increase draft.Place the position control lever in the lowest position and set the implement pull with the draft control lever. Used will have flat wear on the outer edge but will not affect the operation. As the load on the 3-point hitch changes due to various soil conditions, the draft control system automatically responds to these changes by either raising or lowering the implement slightly to maintain a constant pull. Ford Tractor 8N thru 4000 (before 1965) Draft Control Spring. Draft control: This will control the pull of the 3-point implement.Position control :This will control the working depth of 3-point hitch mounted implement regardless of the amount of pull required.
0 kommentar(er)
